server.use-ipv6¶

Default: disable

You can use this setting if lighty was compiled without --disable-ipv6
and you have working IPv6 on your box.

Note: You can bind it to IPv6 sockets freely without enabling this option.

How does it work?¶

If your operating system has not enabled bindv6only
(Linux: sysctl net.ipv6.bindv6only | BSD: sysctl net.inet6.ip6.v6only)
and server.set-v6only is disabled (added and enabled by default since 1.4.27),
it binds to an IPv6 socket and accepts IPv4 connections on it.
This results in IPv4 mapped addresses in the access.log like "::ffff:127.0.0.1".

If you need IPv6 and don't like the mapped addresses, you have to enable bindv6only
or leave this option disabled and bind to the IPv4 address(es) and IPv6 address(es) yourself.

Please use server.use-ipv6 only for hostnames, not without server.bind or empty address.
Your config will break if the kernel default for bindv6only changes.

See also¶

• How do I bind to more than one address?
• IPv6 changes in 1.4.27
• IPv6 and IPv4-mapped addresses